This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
gettingstarted [2011/04/08 13:46] faltin [Smoothest install] |
gettingstarted [2011/04/08 13:53] faltin [Verify that your network is discovered] |
||
---|---|---|---|
Line 40: | Line 40: | ||
+ | ==== Even easier install ==== | ||
+ | * Use our available [[navappliance|virtual appliance]] with NAV preinstalled! | ||
===== Adjust NAV configuration files ===== | ===== Adjust NAV configuration files ===== | ||
Line 160: | Line 162: | ||
After you have registered your equipment in NAV, the background processes starts collecting information with snmp: | After you have registered your equipment in NAV, the background processes starts collecting information with snmp: | ||
- | * [[backendprocesses#ipdevpoll|ipdevpoll]] should notice the new IP device within 2 minutes, and will then classify the new box in terms of OIDs supported. This can be seen from the IP device report from the [[reporttool|report tool]]. | + | * [[backendprocesses#ipdevpoll|ipdevpoll]] should notice the new IP device within 2 minutes and will start collecting switch/router port information and more. Verify the status using the report tool (or network explorer). You may also check the ''ipdevpoll.log'' file. |
- | * The next step for getDeviceData will be to gather switch/router port information and more. Verify the status using the report tool (or network explorer). You may also check the ''ipdevpoll.log'' file. | + | |
After the individual components has its collected data [[backendprocesses#mactrace|mactrace]] will every 15 minutes gather mac to switch port data. This will in turn be used by the | After the individual components has its collected data [[backendprocesses#mactrace|mactrace]] will every 15 minutes gather mac to switch port data. This will in turn be used by the |